1. Run the KontrolToOsc.jar and press start. The PAD leds should flash the main LCD will say NSK v0.1
2. Open Reaktor and configure OSC
At the top, make sure the port number is set to 10000 (or whatever you set Out Port to in the KontrolToOsc app)
Add 2 outgoing connections
Identifier Remote IP Addr. Remote Port<br />
<br />
Kontrol Your IP 10001 (In Port)<br />
Sys Your IP 10002 (Sys Port)<br />
3. Open DrumBox.ens
The Main LCD should change to say P 1 C 1 and the pads might change to show some highlighted in red.
Hit Play in reaktor and the pad leds will flash to show you the sequence position.
There are 3 modes which you can cycle through using the SCENE button
1. Pattern Edit
2. Pattern Sequence
3. Pad Edit a.k.a. Live Mode
In this mode you can edit the channels and patterns. There are 8 available channels (sounds) and 8 patterns.
To toggle a step just press the pad.
To change the pattern use the SETTING and MESSAGE buttons, the main lcd display should change to show you which pattern you are editing.
To change the channel use the SW1 and SW2 buttons and again the main lcd will show you which channel you are on.
In this mode the top 8 pads are used to select which pattern is playing. When you press a pad it will start flashing to indicate that it will
play when this pattern finishes.
In this mode you can edit the individual sounds and play the pads in real time. The currently selected channel will be shown by which PAD lcd is
active.
To edit the current channel use the first 3 sliders
1. Envelope Decay
2. Playback speed
3. Grain Time
In all modes the knobs are used to change the pitch of the samples.